Bushing Guard Installation Guide

DE-ENERGIZED INSTALLATION NOTES

1.

Align one side of the Reliaguard Bushing Guard under the bushing’s uppermost shed. If installing Reliaguard GreyEEL® conductor guard onto conductor, refer to the GreyEEL® installation guide prior to alignment.

2.

Route the conductor out the seam of the Guard at the small fingers. Close the Bushing Guard so that the two loop latches fit into the opposite half’s square receptacles.

3.

Ensure guard is closed by firmly pressing body halves together. This will engage loop latches into their receptacles. Check both loop latches are fully engaged.

Thru-holes are provided for the optional use of push pins or zip ties as a secondary closure. These are not required for retention and are provided
only for convenience of users who prefer a secondary closure method.

DE-ENERGIZED REMOVAL NOTES

Remove Bushing Guard by clipping the zip ties or heads off the black pins with suitable cutter. Then pressing in both loop latch snaps. Separate guard to remove.